BUFFALO WZR-HP-G300NH FIRMWARE 會FIX N+G 問題?

大家有冇WZR-HP-G300NH 新FIRMWARE 既 NEWS 呀?
真係太多BUG 啦~~  (先對不認同者SAY SORRY)

我如果開左40MHZ, 同時有1個11G CLIENT 和11N CLIENT,  就不停DISCONNECT, 係咪我SET 錯呀?

BT 爆SECESSIONS 除左DISABLE 個NETBIOS OVER TCP/IP 仲有咩可以做呀?

原帖由 smallfaihk 於 2009-8-30 10:47 發表
大家有冇WZR-HP-G300NH 新FIRMWARE 既 NEWS 呀?
真係太多BUG 啦~~  (先對不認同者SAY SORRY)

我如果開左40MHZ, 同時有1個11G CLIENT 和11N CLIENT,  就不停DISCONNECT, 係咪 ...

原來你都有咁嫁問題,我見人地個wifi下下detect到,而我個wifi就未必下下detect到
20尺多少少距離都好難detect

TOP

原帖由 smallfaihk 於 2009-8-30 10:47 發表
大家有冇WZR-HP-G300NH 新FIRMWARE 既 NEWS 呀?
真係太多BUG 啦~~  (先對不認同者SAY SORRY)

我如果開左40MHZ, 同時有1個11G CLIENT 和11N CLIENT,  就不停DISCONNECT, 係咪 ...


11G默认是20Mhz
可以说,40Mhz是专门给11N用的

TOP

ok thx brother glk17.  i have got both N and G client... so i can only set 20Mhz?

my N client max speed is 130MB when i place it very close to the router... so it's the max? and can't reach 300MB (even theotorical value)?

TOP

40Mhz Full N Speed
20Mhz Half N Speed
频宽减少一半,自然速度减少一半

单频Router,行11G and 11N Mix时,网内已有11G Client连入,Router只运行最高54Mbps的速率,All Clients降速为54Mbps以下。

向下兼容势必降低性能。

TOP

原帖由 G-核戰機 於 2009-8-30 10:50 發表

原來你都有咁嫁問題,我見人地個wifi下下detect到,而我個wifi就未必下下detect到
20尺多少少距離都好難detect


My 300NH also frequently cannot connect by Wifi, need to reboot... :(

TOP

so should I use 40Mhz? even I have G client??

TOP

http://en.wikipedia.org/wiki/IEEE_802.11n

40 MHz channels is another feature incorporated into 802.11n which doubles the channel width from 20 MHz in previous 802.11 PHYs to transmit data. This allows for a doubling of the PHY data rate over a single 20 MHz channel. It can be enabled in the 5 GHz mode, or within the 2.4 GHz if there is knowledge that it will not interfere with any other 802.11 or non-802.11 (such as Bluetooth) system using those same frequencies

其實如果有B/G CLIENT 有N ROUTER/AP 都冇用.

TOP

原帖由 docomohk2003 於 2009-8-31 10:36 發表
so should I use 40Mhz? even I have G client??


如果是我,我会尽量把所有的G Client升级为N
一般本本的内置模块只有2种,Old:Mini PCI,New:Mini PCI-E
像一些常见的N模块,其实也不贵的,都在¥100~¥200以内
Intel 5350,AR5008,BCM4321,Marvell 88w8363等等。。。

然后Router行 11n only,40Mhz

TOP

thanks brother but that G client is my mobile phone.....
so nowadays many of them still use G..

TOP