TP-LINK WDR4900 磚左

昨天多手學人裝DD WRT firmware, REBOOT後打192.168.1.1或192.168.0.1都入唔到SETUP 畫面, 應該係磚左, 想請問有無Ching識裝返原廠firmware? 謝謝

Ching, 我晤係專家,我都係早幾日flash
ddwrt, 又係192.168.0.1或192.168.1.1入唔到setup
你試試入cmd
ping -t loop 回一個ip就好似係setup page
唔得的話我都唔識,希望你啱用

TOP

Ching, 我晤係專家,我都係早幾日flash
ddwrt, 又係192.168.0.1或192.168.1.1入唔到setup
你試試入cmd
pin ...
xiaohung 發表於 2014-11-1 10:57


唔該xiahung 兄, 今晚回家試下, 希望得啦

TOP

brick左就要買ttl線同排針黎de-brick番部機wor
排針焊上圖中TX/RX/GND個位
http://wiki.openwrt.org/toh/tp-link/tl-wdr4900#photos
de-brick方法自己睇
http://wiki.openwrt.org/toh/tp-l ... or.oem.installation
ttl線同排針可以係tb搵

TOP

部router着著什么燈?識吾識派IP先?

TOP

本帖最後由 tomleehk 於 2014-11-1 20:14 編輯

Even the router 吾識派IP does not mean it already turned into brick, sometimes it is just the DHCP function failure after flashing.

You just need to manually set your PC's IP address to  192.168.1.2 / 255.255.255.0 / 192.168.1.1 and connect your PC to the router's LAN port, then try if you can ping your router's IP address 192.168.1.1.

If there is response from 192.168.1.1, there can be many ways to resolve..

I encountered similar situation many times before and ultimately sorted out a way to resume.

TOP

Even the router 吾識派IP does not mean it already turned into brick, sometimes it is just the DHCP f ...
tomleehk 發表於 2014-11-1 19:18


多谢師虎,又有機會學野了。

TOP

本帖最後由 Monet90 於 2014-11-5 11:36 編輯

謝謝名位ching解答, 原來我部4900係刷左Openwrt firmware, 剛已跟網上指示用Telnet 改左password, 另外Openwrt網上有教改回用原廠firmware方法如下:

Revert to stock firmware by following these steps:

-Download / copy with SCP or wget this firmware to the /tmp folder of the router: ftp://everbest.ftpserver.biz/Sha ... 900nv1_en_3_14_1_up(130304)_beta.bin
-Open a SSH session to the router, cd to /tmp
-Execute the following command: mtd -r write wdr4900nv1_en_3_14_1_up(130304)_beta.bin firmware-
-Wait until the router reboots

第一點唔係好明, 點樣可以將回下載的firmware 放入router內的/tmp?
另外第二點Open a SSH session又係點做?
請問有無ching可以教我?

TOP

謝謝名位ching解答, 原來我部4900係刷左Openwrt firmware, 剛已跟網上指示用Telnet 改左password, 另外Open ...
Monet90 發表於 2014-11-5 11:33

openwrt 仲好用過 ddwrt, 試下先啦, putty入到 ?
係唔係未裝luci ?
http://wiki.openwrt.org/doc/howto/luci.essentials

TOP

openwrt 仲好用過 ddwrt, 試下先啦, putty入到 ?
係唔係未裝luci ?
Bomber 發表於 2014-11-5 12:24


因為小弟唔係好熟openwrt, 暫時只想用回廠firmware, 有無ching教我點做,謝謝

TOP