[測試] Wake On Lan with Netgear R7000

本帖最後由 goconnect 於 2015-12-23 11:07 編輯

Hi,

在netgear 網見有人寫個steps:

1.Download TelnetEnable from here: https://github.com/LuKePicci/NetgearTelnetEnable/b​lob/master/binaries/windows/telnetenable.exe?raw=t​...
2.Open a DoS/Command Prompt on a PC directly connected to the same LAN and type 'telnetenable.exe <router-IP> <router-MAC> admin <admin-password>'
3.Telnet to the router
4.Type 'arp -i br0 -s x.x.x.x mm:mm:mm:mm:mm:mm' where x.x.x.x is the WoL destination IP address (not .255) and mm... is
the WoL destination's MAC address

You should then have a static ARP entry in your router.  Set up forwarding of port 9/UDP to your device you want to wake and it should work.

請問這是在offical netgear firmware 上做完可以WOL 嗎?
(舊post覆不到,只能開新post見諒)