Blue screen問題

本帖最後由 sfij 於 2015-8-13 18:36 編輯

Win 7 Enterprise
CPU: Intel E8400
MB: Asus P5Q
Ram: Kingston ddr2 800 x 2GB + 1066 x 2GB
SSD: Plextor M6S 128GB
HDD: Toshiba 2TB + WD Green 2TB
Display: xFx 9500GT

用bluescreen viewer出咗以下資料:
未命名.png
2015-8-8 21:44


請ching指教下點解決...!!
thx~!

剛剛又Blue Screen...
未命名2.png
2015-8-13 18:35

今次係display driver...但上咗nvidia 度check...已經係最新
次次都有ntoskrnl.exe...關唔關事?
求ching指教!!
thx~

TOP

又blue screen 了
未命名3.png
2015-8-14 08:56


請各ching打救!!!

TOP

建議跑轉mentest86+

TOP

有無裝plexturbo? 我早排新買m6s 翻黎有裝,間中唔夠ram 會blue screen, uninstall 之後就無咗哩個問題

TOP

有無裝plexturbo? 我早排新買m6s 翻黎有裝,間中唔夠ram 會blue screen, uninstall 之後就無咗哩個問題 ...
hobt4213 發表於 2015-8-17 01:33


無有裝過...
thx

TOP

回覆 3# sfij

把下列 兩個 dump file 上載到 OneDrive 分享
081415-9812-01.dmp
081315-10062-01.dmp

我如有閑暇時間的話研究一個(不保證一定可解決問題)

另外, 只單用 bluescreenview 查看藍屏, 其實係虛有其表, 得個"睇"字

TOP

藍屏成因太多,任何軟/硬件均可導致,上嚟問係不設實際,一定要見到部機先逐樣試.

TOP

本帖最後由 sfij 於 2015-8-17 19:38 編輯
回覆  sfij

把下列 兩個 dump file 上載到 OneDrive 分享
081415-9812-01.dmp
081315-10062-01.dmp

我如 ...
mpegdecoder 發表於 2015-8-17 11:55


Here are the dmp files:
http://1drv.ms/1NniKmi

Thanks c hing!
有樣嘢唔係幾肯定,唔記得係咪每次hang機都有駁住VPN的,但有幾次係有駁VPN...唔知關唔關事....

TOP

Debug 分析完成兩個 dump file
兩個 crash dmp 都源自指向同一個 .sys 文件 L1E62x64.sys
  1. BugCheck D1, {18000000428, 2, 0, fffff880020a57d1}

  2. Probably caused by : L1E62x64.sys ( L1E62x64+760a )


  3. DRIVER_IRQL_NOT_LESS_OR_EQUAL (d1)
  4. An attempt was made to access a pageable (or completely invalid) address at an
  5. interrupt request level (IRQL) that is too high.  This is usually
  6. caused by drivers using improper addresses.
  7. If kernel debugger is available get stack backtrace.
  8. Arguments:
  9. Arg1: 0000018000000428, memory referenced
  10. Arg2: 0000000000000002, IRQL
  11. Arg3: 0000000000000000, value 0 = read operation, 1 = write operation
  12. Arg4: fffff880020a57d1, address which referenced memory

  13. Debugging Details:
  14. ------------------
  15. READ_ADDRESS: GetPointerFromAddress: unable to read from fffff80004317100
  16. 0000018000000428

  17. CURRENT_IRQL:  0

  18. FAULTING_IP:
  19. ndis!NdisQueryNetBufferPhysicalCount+11
  20. fffff880`020a57d1 443b4228        cmp     r8d,dword ptr [rdx+28h]

  21. CUSTOMER_CRASH_COUNT:  1

  22. DEFAULT_BUCKET_ID:  VISTA_DRIVER_FAULT

  23. BUGCHECK_STR:  0xD1

  24. TRAP_FRAME:  fffff880051b5320 -- (.trap 0xfffff880051b5320)
  25. NOTE: The trap frame does not contain all registers.
  26. Some register values may be zeroed or incorrect.
  27. rax=0000000000000000 rbx=0000000000000000 rcx=fffffa800667c1d0
  28. rdx=0000018000000400 rsi=0000000000000000 rdi=0000000000000000
  29. rip=fffff880020a57d1 rsp=fffff880051b54b8 rbp=fffffa8003e055c0
  30. r8=000000000000008b  r9=0000000000000065 r10=0000000000000000
  31. r11=fffffa80069df840 r12=0000000000000000 r13=0000000000000000
  32. r14=0000000000000000 r15=0000000000000000
  33. iopl=0         nv up ei pl nz na po nc
  34. ndis!NdisQueryNetBufferPhysicalCount+0x11:
  35. fffff880`020a57d1 443b4228        cmp     r8d,dword ptr [rdx+28h] ds:f840:00000180`00000428=????????
複製代碼
  1. BugCheck A, {100000000, 2, 0, fffff800040c1640}

  2. Probably caused by : L1E62x64.sys ( L1E62x64+76b8 )


  3. IRQL_NOT_LESS_OR_EQUAL (a)
  4. An attempt was made to access a pageable (or completely invalid) address at an
  5. interrupt request level (IRQL) that is too high.  This is usually
  6. caused by drivers using improper addresses.
  7. If a kernel debugger is available get the stack backtrace.
  8. Arguments:
  9. Arg1: 0000000100000000, memory referenced
  10. Arg2: 0000000000000002, IRQL
  11. Arg3: 0000000000000000, bitfield :
  12.         bit 0 : value 0 = read operation, 1 = write operation
  13.         bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
  14. Arg4: fffff800040c1640, address which referenced memory

  15. Debugging Details:
  16. ------------------
  17. READ_ADDRESS: GetPointerFromAddress: unable to read from fffff800042fd100
  18. 0000000100000000

  19. CURRENT_IRQL:  0

  20. FAULTING_IP:
  21. nt!RtlCopyMemoryNonTemporal+40
  22. fffff800`040c1640 4c8b0c11        mov     r9,qword ptr [rcx+rdx]

  23. CUSTOMER_CRASH_COUNT:  1

  24. DEFAULT_BUCKET_ID:  VISTA_DRIVER_FAULT

  25. BUGCHECK_STR:  0xA

  26. TRAP_FRAME:  fffff88004ecff60 -- (.trap 0xfffff88004ecff60)
  27. NOTE: The trap frame does not contain all registers.
  28. Some register values may be zeroed or incorrect.
  29. rax=00000000000000c0 rbx=0000000000000000 rcx=fffff8800cbf7000
  30. rdx=00000780f3409000 rsi=0000000000000000 rdi=0000000000000000
  31. rip=fffff800040c1640 rsp=fffff88004ed00f8 rbp=0000000000000002
  32. r8=0000000000000025  r9=0000000000000000 r10=fffffa8006484250
  33. r11=fffff88004ed00e0 r12=0000000000000000 r13=0000000000000000
  34. r14=0000000000000000 r15=0000000000000000
  35. iopl=0         nv up ei pl nz na po nc
  36. nt!RtlCopyMemoryNonTemporal+0x40:
  37. fffff800`040c1640 4c8b0c11        mov     r9,qword ptr [rcx+rdx] ds:0001:00000001`00000000=????????????????
複製代碼
這個 L1E62x64.sys 係唯一造成 crash 原因
應該係某網卡驅動程式之類的系統文件

自行判斷
good luck!

TOP