求救~硬管工具

求救~硬管工具
謝謝
下面兩套比較建議用邊套
及把熱風槍要用幾多火數的
1.jpg
2016-8-1 00:31

2.jpg
2016-8-1 00:31

我自己多數用第一套

TOP

我自己多數用第一套
NG 發表於 2016-8-1 11:39


ok 謝謝

TOP

回覆 1# 9s9s9


第一套既彎位好大,一個彎差唔多5cm
我通常會用第二套,或者就咁吹等佢自然彎曲,咁d角會細d同靚d
用幾度我就無睇過,反正我只開一半,
吹緊時要不停轉支管,唔係好易會起泡,
吹一兩支屈角自己會就得到架啦

TOP

回覆  9s9s9


第一套既彎位好大,一個彎差唔多5cm
我通常會用第二套,或者就咁吹等佢自然彎曲,咁d角會細 ...
fanhoikwai 發表於 2016-8-3 14:21



    謝謝 明白晒
原來第一套的彎角最少有成5CM咁多 多謝說明
咁第二套會方便點了

TOP

我用2

搭單一問,你地多數開機多度黎吹? 管要離槍口幾遠?

TOP

I use #1. Ching is correct, the bending width is 5th or more. need to have full size case.

TOP

回覆 6# inori


Any heat gun I use, always use low heat.. overheating create bubble, and nonsmooth bending. Distance depends on how complex the bend is, normally 90-degree bend about 5-10cm. Just my experience, any ching can share?

TOP

I use #1. Ching is correct, the bending width is 5th or more. need to have full size case.
An17d 發表於 2016-8-13 19:22
回覆  inori


Any heat gun I use, always use low heat.. overheating create bubble, and nonsmooth b ...
An17d 發表於 2016-8-13 19:25

thx alot
i order it already just waiting.........

TOP

No problem! Good luck!

TOP