介紹一款$87.2 nucleo-f446RE

一款$87元超乎coryex M4 MCU 開發板, 它有arduino extension槽, 。

[img][/img]

nucleo-f446RE

Nucleo_Board_64_DSL.jpg

TOP

STM32 Nucleo-64 development board with STM32F446RET6 MCU, supports Arduino and ST morpho connectivity.

Key Features
◾STM32 microcontroller with LQFP64 package
◾Two types of extension resources
•Arduino Uno Revision 3 connectivity
•STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os
◾mbed-enabled (http://mbed.org)
◾On-board ST-LINK/V2-1 debugger/programmer with SWD connector
•selection-mode switch to use the kit as a standalone ST-LINK/V2-1
◾Flexible board power supply
•USB VBUS or external source(3.3 V, 5 V, 7 - 12 V)
•Power management access point
◾Three LEDs
•USB communication (LD1), user LED (LD2), power LED (LD3)
◾Two push buttons: USER and RESET
◾USB re-enumeration capability: three different interfaces supported on USB
•Virtual Com port
•Mass storage
•Debug port
◾Supported by wide choice of Integrated Development Environments (IDEs) including IAR™, Keil®, GCC-based IDEs

http://www.st.com/web/catalog/to ... archtype=partnumber

TOP

◾mbed-enabled (http://mbed.org)

mbed 有大老細照,有機成主流!

TOP

Can it run arduino library?

TOP

Can it run arduino library?
Sora 發表於 2015-9-17 13:21


It just only uses ST libraries but it has an arduino pin out for all arduino's extension cards

TOP

It just only uses ST libraries but it has an arduino pin out for all arduino's extension cards
unixman 發表於 2015-9-17 21:54



    好似可以load個arduino bootloader同其他野入去

TOP

好似可以load個arduino bootloader同其他野入去
eh 發表於 2015-9-22 11:09


There is no official arduino bootloader and STM32CubeF4 library is used to program a STM32 nucleo.

TOP

一款$87元超乎coryex M4 MCU 開發板, 它有arduino extension槽, 。
unixman 發表於 2015-9-15 00:16



請問這板上有多少個 general purpose IO 可用呢

TOP

請問這板上有多少個 general purpose IO 可用呢
xiao 發表於 2015-10-5 13:38


There are 50 GPIOs on Morpho expansion connectivity and 22 GPIOs on Arduino expansion connectivity .

TOP