新手整亞加力膠側板問題

提示: 作者被禁止或刪除 內容自動屏蔽

提示: 作者被禁止或刪除 內容自動屏蔽

TOP

人手cut得啦,手擰鏍絲新高登2/f有得賣

TOP

提示: 作者被禁止或刪除 內容自動屏蔽

TOP

原帖由 xERIC 於 2009-3-7 15:02 發表
想幫CM690整個透明側板
(即係成個側板都係用亞加力膠板)
1.用LASER CUT黎CUT,加風扇洞好唔好?定係人手CUT?
2.去邊買?大信好嗎?一塊ATX側板大約幾錢?
3.去邊有得買手擰鏍絲?(即係個頂係圓,側邊個6邊果D)
唔該晒CHING

1. expensive....
2. atx side pannel..... not fit for all model case. cm690 can buy from hornington
3.golden or ask some shop to provided.


p.s. why don't find a-sir

TOP

提示: 作者被禁止或刪除 內容自動屏蔽

TOP

你學校有laser梗係用laser啦...我以為你拎出去比錢人cut..比人cut好貴

TOP

原帖由 xERIC 於 2009-3-7 19:49 發表
1.我學校DT LAB有LASER CUT
2.
3.遲D去睇下先,果D叫咩名
P.S.想自己DIY


想全透明 @.@
but at least you need a lock connect to the case ...
i made one because i am lazy before .. just stick on the case is fine ...
a uv board size as same as orginal + double size tape. done

TOP

提示: 作者被禁止或刪除 內容自動屏蔽

TOP

4mm ok, 太薄好難收羅c, 太厚好重

TOP