10x10cm PLA 成本幾錢?

thx.......

thx.......
praxis 發表於 2015-3-16 23:52



    呢個是面積,沒高度所以應該是零

TOP

回覆 2# Offer

thx Offer:  10 cm cube.

TOP

TOP

回覆 4# fred2088

thx fred but bit complicated.

TOP

本帖最後由 kenchiuon 於 2015-3-17 15:06 編輯

回覆 5# praxis

Not that Difficult...
http://www.toybuilderlabs.com/bl ... t-volume-and-length
3.00 mm filament length for 1 kg spool: ~ 110 meters / ~ 360 feet

if count from Slic3R cut will 25% infill for a 10mm cube, it need about 159.04mm of filament used
Capture.JPG
2015-3-17 13:45


Then, if 1KG 3mm cost HK$100, it can produce 691 piece of 10mm cube, at about $0.14 per one. you can draw a 10CM to count it then..

TOP

成本又唔止來自材料ge...樓主要落埋電錶先計到...

TOP

見商店賣3d print service $99. 10cm cube.

TOP

回覆 8# praxis

佢用乜機幫你印呢?  用HKD幾百萬一台的 Objet 的話,無收貴你喎

TOP

回覆 9# ma_hty

objet .... 好難!  

TOP