印成咁係邊度出問題?

DSC_1976.JPG
2016-1-22 16:49

已經玩左成兩個星期,噴頭加熱管等都換左好多零件.都係唔得.呢張相已經算係幾好.
而家估一係送料部份出問題.

Ching, 你部係乜野機?

TOP

咩溫度?
咩速度?
Extruder 有無達達聲?
齒輪有無膠碎?
膠幾粗? (卡尺同一個位度3個角度, 10 cm 一段分別度3次, 最大,最小, 最常出現尺寸?)

TOP

咁樣睇係有underextrusion喎,出膠唔正常

TOP

不如你試印20x20x20 test cube 先

TOP

好可能測温sensor 唔準!

TOP

makerbot replicator 2.
用用下有問題一路換野,PLA 1.75 0.4mm咀.
換左方鋁塊,發熱管,零件淘返黎.而家覺得應該唔關事.
換完之後有噴咀SENSOR ERROR #4.
Heating Failure #4
Message on screen : "Heating Failure #4 my temperature reads are failing! Please check my connections."
Printer will : The printer will turn off the related heater cartridge by try and still print...you need to cancel the job
What is happening: The machine is unable to detect the THERMOCOUPLER either because it is damaged or disconnected.
Solution : Check the cable for damage at both ends
但係可以照印,原來個SENSOR係唔同淘返黎嗰啲,換返個原裝SENSOR落去都照有ERROR,照印出黎就係咁.我裝返原裝SENSOR有ERROR攞個火機燒佢部機又顯示到溫度喎.
其實有啲諗或者係噴咀,用左三間唔同舖噴咀,有啲印出黎真係好衰,而家呢份係換另一個噴咀就印得好左.LOAD FILAMENT嗰陣出膠同原廠噴咀都好唔同.

TOP

TOP

向上噴只係噴咀有小小炭屎黐住啫,問題不大

TOP

回覆 7# marcowing

睇 error messge 應該係噴頭 測温 sensor 問題

1.噴頭 sensor 安裝得唔好,無貼實個鋁方。
2.條 sensor 線有地方斷咗,但又欲斷難斷,攪到運作時,一時有測温一時無。
3.條 sensor 線連接底版嘅螺絲位無上好,有接觸不良嘅情況發生。

先check咗呢三樣嘢先!

TOP