Board logo

標題: Zyxel 460N + netvigator setting 問題 [打印本頁]

作者: fatzaku2    時間: 2009-3-23 10:51     標題: Zyxel 460N + netvigator setting 問題

用開網上痕上網 自己加隻router 一切正常

禽日買左隻 新既 Zyxel 460N  打算攪番d setting
插好晒d 線 跟menu 打http://192.168.1.1/ 準備入router setting page..

點知佢不停轉去 網上行個set up page http://setup.net/getpage.gch?pid=1001  
叫我入username 同pw..
因為佢呢版應該係 網上痕 隻wireless modem 工程網 settiing
我入d user pw 入去係唔work 既.. 而我一早已cut 左佢個wireless service

請問.. 點先可以好似正常咁 打http://192.168.1.1/  入去router set up page.
( 已check networking 係用auto ip同dhpc)
many thanks!!
作者: airlo    時間: 2009-3-23 11:09

原帖由 fatzaku2 於 2009-3-23 10:51 發表
用開網上痕上網 自己加隻router 一切正常

禽日買左隻 新既 Zyxel 460N  打算攪番d setting
插好晒d 線 跟menu 打http://192.168.1.1/ 準備入router setting page..

點知佢不停轉去 網上行個set up page http://set ...

就咁插LAN駁電腦, 唔好插WAN port 住咪得囉
作者: fatzaku2    時間: 2009-3-23 11:13

原帖由 airlo 於 2009-3-23 11:09 發表

就咁插LAN駁電腦, 唔好插WAN port 住咪得囉


thanks
但試過唔得 唔插佢就 load load load 192.168.1.1
time out 出唔到page...
作者: Midas    時間: 2009-3-23 11:18

用隻傻瓜 setup 碟做 setting 得唔得?
作者: airlo    時間: 2009-3-23 11:18

原帖由 fatzaku2 於 2009-3-23 11:13 發表


thanks
但試過唔得 唔插佢就 load load load 192.168.1.1
time out 出唔到page...

有無打CMD睇睇佢派唔派到DHCP?
如果派唔到咪RESET佢囉, DEFUALT一定會派到ip
作者: fatzaku2    時間: 2009-3-23 11:22

原帖由 Midas 於 2009-3-23 11:18 發表
用隻傻瓜 setup 碟做 setting 得唔得?


隻 cd 佢check 完 hardware device
去到第三park check internet setting 就出error
叫我re-boot device..
攪完都係唔得...
作者: fatzaku2    時間: 2009-3-23 11:26

原帖由 airlo 於 2009-3-23 11:18 發表

有無打CMD睇睇佢派唔派到DHCP?
如果派唔到咪RESET佢囉, DEFUALT一定會派到ip


可唔可以 詳細講講點攪
新手 唔明 thanks
作者: Midas    時間: 2009-3-23 11:27

原帖由 fatzaku2 於 2009-3-23 11:22 發表


隻 cd 佢check 完 hardware device
去到第三park check internet setting 就出error
叫我re-boot device..
攪完都係唔得...

有無 reset 過部機啊!所有 460N 都要咁做先可做 setup!唔好問我點解...
作者: fatzaku2    時間: 2009-3-23 11:43

原帖由 Midas 於 2009-3-23 11:27 發表

有無 reset 過部機啊!所有 460N 都要咁做先可做 setup!唔好問我點解...


即係 用那個setup 程式 就例出error
跟手 click 460  個reset 再來一次就會 pass到呢個step 再auto set 落去?
thanks
作者: hkepczeg    時間: 2009-3-23 11:57

All you need to do is........

1. turn off N460
2. disconnect the IMS broadband modem from N460
3.turn on the N460 again
(this time, the N460's DCHP should work and assign a valid IP address for your computer.)
4.only after you are able to enter the config page of the N460, should you reconnect the broadband modem to the N460
作者: fatzaku2    時間: 2009-3-23 12:05

原帖由 hkepczeg 於 2009-3-23 11:57 發表
All you need to do is........

1. turn off N460
2. disconnect the IMS broadband modem from N460
3.turn on the N460 again
(this time, the N460's DCHP should work and assign a valid IP address for your  ...



唔好意思  係咪即係咁 有錯請指正 thanks!
1. n460 插晒 ims modem  (wan) + 電腦 (lan)
2. 開晒.. run 個set up programme ... 去到check internet setting 出 error 個part
3, 熄 n460
4. 拔走 ims modem
5. 開番n460
6. 再run 個  set up programme , 應該可以過到internet setting check 再run 落去

小弟好生手.. 麻煩指正 many thnaks
作者: hkepczeg    時間: 2009-3-23 12:09

"1. n460 插晒 ims modem  (wan) + 電腦 (lan)"

NO, NO!
****Don't 插 ims modem to N460 at the beginning****

run 個  set up programme , 應該可以過到internet setting check then *插* ims modem落去
作者: fatzaku2    時間: 2009-3-23 12:13

原帖由 hkepczeg 於 2009-3-23 12:09 發表
"1. n460 插晒 ims modem  (wan) + 電腦 (lan)"

NO, NO!
****Don't 插 ims modem to N460 at the beginning****

run 個  set up programme , 應該可以過到internet setting check then *插* ims modem落去


revise 即係咁 ? 麻煩晒

1. n460 插 電腦 (lan)
2.  run 個set up programme ... 去到check internet setting
3, 過左check internet setting 那關
4. 快手插入 ims modem

thanks!
作者: hkepczeg    時間: 2009-3-23 12:20

YES!
作者: poontat2000    時間: 2009-3-23 12:21

原帖由 Midas 於 2009-3-23 11:27 發表

有無 reset 過部機啊!所有 460N 都要咁做先可做 setup!唔好問我點解...


真係所以都要reset....??
最少我果部無....
作者: fatzaku2    時間: 2009-3-23 12:29

原帖由 hkepczeg 於 2009-3-23 12:20 發表
YES!


many thanks!
今晚番去再試 希望攪得惦





歡迎光臨 電腦領域 HKEPC Hardware (https://www.hkepc.com/forum/) Powered by Discuz! 7.2