MikroTik RouterOS 5.19 Release ~ 07/19/2012

What's new in 5.19 (2012-Jul-16 10:51):

*) ssh - added /ip ssh regenerate-host-key which will regenerate current host key;
*) dhcpv6 client - fix multiple advertise handling;
*) snmp - fix v3 engineID discovery;
*) fix ticking sound on RB411UAHL;
*) user manager - fixed byte to KiB, MiB and GiB conversion
  (digit after decimal point was incorectly calculated);
*) fix routerboard firmware upgrade on RB951-2n;
*) sniffer/torch + simple queues sometimes could crash router;

What's new in 5.18 (2012-Jun-21 17:20):

*) fixed upgrade problem when it failed with error "disk is too small" while
   there was plenty of space left;
*) fix health and poe access reliability on OmniTIK UPA and RB750UP boards;
*) sstp - improve initial handshake to better handle many new connections;
*) wireless - do not use bridge and WDS mode on AP-AP links, causes loops;
*) dhcp ipv6 pd client - fixed ipv6 pool creation after reboot;
*) dhcp ipv6 pd client - added option add-default-route;
*) sstp - fixed connection idle time reporting;
*) fix bad block count not to increase on Samsung K9F1208U0C nand;
*) snmp - fix dhcp lease table, snmp reported an incorrect information
    when a static lease had configured different address than current active address,
    this should also solve problem with dude polling same leases over and over again;
*) fix RB1100 crash on interface disable/l2mtu change/reboot;
*) dns could not resolve some domain names, was ignoring replies with DNAME RRs;
*) fix firewall log action - sometimes was not logging mac addr;

What's new in 5.17 (2012-May-28 12:34):

*) files - fixed problem when directories disappeared after reboot on usb or sd flash;
*) webfig - make QuickSet scan list work in Firefox v12;
*) webfig - fixed problem in QuickSet when changing country or channel-width in AP
   mode would enable NV2 protocol;
*) webfig - fixed skins when hiding first tab may make other tabs inaccessible;
*) winbox - fixed packet raw data view in packet sniffer;
*) winbox - fixed problem when router could be DoS attacked through winbox port;
*) ports - add option "/port firmware ignore-directip-modem"
    which will ignore modems ip interface and modem's serial ports will be made accessible to users;
*) ipv6 pool - allow pools with prefix equal to prefix length;
*) ping times improved on Nv2 high data rate wireless links;
*) tool email - added starttls option;
*) snmp - allow multiple ip ranges for each community;
*) serial console - added channel support;


回復 1# idolclub