I bought ECS G41T-M5 today. Wish me luck~

TOP

睇完覺得個機箱好正!
好細!好慳位!

TOP

原帖由 daigorho 於 2009-10-3 17:32 發表
I bought ECS G41T-M5 today. Wish me luck~

你呢塊板仲細過我果塊MP-G31-MSS, 應該冇問題, 放心
想問吓買左幾多錢??

TOP

回覆 123# 的帖子

$380 from Comdxx
I installed it finally in my RC-100 and so far so good except, the front panel connector (power/HD LED, power switch) is too far away from the panel and those wires are too short. I need to DIY and extend them

TOP

原帖由 daigorho 於 2009-10-4 09:20 發表
$380 from Comdxx
I installed it finally in my RC-100 and so far so good except, the front panel connector (power/HD LED, power switch) is too far away from the panel and those wires are too short. I n ...


Good price for a G41 board; Good board for Elite-100;
Good job of DIY to fit the special layout issue of the board

TOP

I use AsRock N68-S. I confirm it can fit inside the case with a 3.5" drive.

[ 本帖最後由 FireBlack 於 2009-10-4 15:15 編輯 ]
N68-S(Enlarge).jpg

TOP

原帖由 daigorho 於 2009-10-3 17:32 發表
I bought ECS G41T-M5 today. Wish me luck~


I have investigated ECS G41T-M5 too. I want to use E3200, but the CPU list on the ECS web site does not have E3200. I emailed ECS to ask, and the support person replied that E3200 too new, and is not supported. So I give up and use AsRock N68-S instead (with Athlon II 240).

TOP

原帖由 daigorho 於 2009-10-3 17:32 發表
I bought ECS G41T-M5 today. Wish me luck~


CHing唔買dvi版?!可以用轉頭出hdmi(不過唔知有冇聲音出…)

TOP

原帖由 阿Gong 於 2009-10-4 21:52 發表


CHing唔買dvi版?!可以用轉頭出hdmi(不過唔知有冇聲音出…)


I prefer a DVI board, but I cannot find a DVI MATX board that is 18cm or shorter (otherwise 3.5" hard disk won't fit and you need to use 2.5" hard disk). I can only find ITX boards that are shorter than 18cm and have DVI, but they are expensive.

Do you have any recommendation?

[ 本帖最後由 FireBlack 於 2009-10-4 23:45 編輯 ]

TOP

原帖由 FireBlack 於 2009-10-4 15:13 發表
I use AsRock N68-S. I confirm it can fit inside the case with a 3.5" drive.

This is another good choice for Elite-100

TOP