my strange modded case

TOP

好多 version 之前既 config , 而家已經人面全非 ...

TOP

原帖由 孔明仔 於 2006-2-5 21:01 發表
好多 version 之前既 config , 而家已經人面全非 ...

D線去左行大運
全部都兜圈

TOP

原帖由 HPI_PRO4 於 2006-2-5 23:29 發表

D線去左行大運
全部都兜圈

如果唔係飛到通街都係 , 根本唔通風

TOP

TOP

原帖由 jeffkim 於 2006-2-7 19:30 發表


why dont you add a 12cm fan at the rear of your Chieftec ar ??

TOP

原帖由 highflyer 於 2006-2-7 21:42 發表


why dont you add a 12cm fan at the rear of your Chieftec ar ??


如果冇睇錯, 前面都冇空氣入.
亦都冇空氣出(只靠隻牛牛)...
嚴重散熱不足~

TOP

With a closer look, this Chieftec case should have a front 8cm fan behind the front panel.  The lower part of the front panel has small openings along sides of the vertical channels for air-intake.
The rear fan should not be 12cm (my overlook) but a 9cm one.  There should also be a 9cm fan for the harddisks and a 9cm fan opening on the side panel too.  Typical of the Dragon series.

TOP

原帖由 highflyer 於 2006-2-7 21:42 發表


why dont you add a 12cm fan at the rear of your Chieftec ar ??


不瞞你說...呢套機我尋日先叫砌好...
完成度大約80-90%左右...機內好多SETTING都未搞...
我唔裝風扇最主要原因係我冇12CM同9CM風扇...
不過而家側蓋都係就咁打開..所以冇咩影響...
CPU..DISPLAY FULLLOAD溫度都正常...
純粹係想分享下砌新機既喜悅o姐

TOP

原帖由 highflyer 於 2006-2-7 23:12 發表
With a closer look, this Chieftec case should have a front 8cm fan behind the front panel.  The lower part of the front panel has small openings along sides of the vertical channels for air-intake. ...


嗯...呢個機箱係我同一個網友2手買返呢...不過機箱係全新的...而且價錢相當優惠..
呢個箱係前12cm後9cm....hd位隔離果個風扇位係8cm..唔係9cm...

TOP