焊LCD 坡璃請教.

近來有一部舊機, 佢原本係用RIBBON 把PCB 同埋LCD 接埋, 類似圖咁款,



但近來RIBBON 好似有問題, 有間紋, 而RIBBON 係有特定設計唔係直排就咁買來換到, 而且部機己經都差唔多25 年, RIBBON 都快硬化硊化了, 於是想唸下可唔可以用80 PIN 的IDE 線在LCD PANEL 直接焊上

器材上我可以有熱風焊, 有隻白光的恆溫雞, 鍚膏, 銀漆等等, LCD 和PCB 的金手指大約1MM, 足夠手工焊掉,
但LCD 只係一層好薄的ITO, 如果用鍚膏可或者銀漆WORK 唔WORK 可以上鍚接埋佢.

抑或一定係要用佢地果款RIBBON 才能夠接, 如果重焊, 咁應該用幾多度, 同埋乜野鍚線來焊.

感謝指教.
附件: 您需要登錄才可以下載或查看附件。沒有帳號?註冊

This is old type of heat bonding ribbon cable. I think you should be able to solder to the pcb side if you can find right pitch cable or connector. But that is not really possible for the LCD side. Since the connections are printed on the glass which you can't just do soldering on it.

TOP

玻璃果便一定係要用佢地果款RIBBON 才能夠接

google heat seal connector

TOP

要用外熱烙鐵 + 呢d呢d ,買條新班馬線壓返喎...

TOP