QNAP TVS-463 換HDD

早排部NAS QNAP TVS-463 HDD3 着橙燈咁叫, 出err, 咁我以為佢壞咗HDD, 今日換咗新既HDD, 但唔識自己重建返raid, 請問各位大大點解決呀
nas1.jpg
2019-10-23 14:06

nas2.jpg
2019-10-23 14:06

磁碟/VJBOD見唔見到隻新碟?

TOP

本帖最後由 canonikony 於 2019-10-23 14:34 編輯
磁碟/VJBOD見唔見到隻新碟?
lnchu 發表於 2019-10-23 14:18


見到  
nas3.jpg
2019-10-23 14:28


PS呢隻係舊HDD, 之前會間唔中出err, 啱啱我放返落去試, 諗住會認到, 但都係咁, raid食唔返隻野

TOP

rps20191023_162816.jpg
2019-10-23 16:28

TOP

lnchu 發表於 2019-10-23 16:29


第二張圖個度, raid認唔到HDD3, 無法做修復

TOP

In some cases the rebuild of the RAID might not start automatically. If you encounter this you may set the new drive as a spare disk first. The rebuild will start immediately after this is done.

To set the new drive as a spare disk, please follow the steps below:

Log in to your NAS via web browser
Open Storage & Snapshots
Go to Storage > Storage/Snapshots
Select your Storage Pool or Static Volume and click on the “Manage” button
Select the degraded RAID group section and click “Manage” and then “Configure Spare Disk”.
Select the new drive and click Apply
試試把新碟"設定為備用磁碟".
唔得快backup, call support.可能個raid config file corrupted.

TOP

見到  


PS呢隻係舊HDD, 之前會間唔中出err, 啱啱我放返落去試, 諗住會認到, 但都係咁, raid食唔返隻野 ...
canonikony 發表於 2019-10-23 14:28



    你隻舊HDD, 有沒清空內容先放入NAS?

TOP

你隻舊HDD, 有沒清空內容先放入NAS?
炎冬 發表於 2019-10-23 23:24



    新都係一樣, NAS認到, 但raid食唔到, 所以先放返舊個隻落去試下睇下係咪一樣, 就算舊HDD 攞咗出黎, 應該唔駛清空吧, 最多係sync返???

TOP

In some cases the rebuild of the RAID might not start automatically. If you encounter this you may s ...
lnchu 發表於 2019-10-23 19:38


呢個可以試下, 但我想backup一次先, 驚無哂野

TOP

In some cases the rebuild of the RAID might not start automatically. If you encounter this you may s ...
lnchu 發表於 2019-10-23 19:38



    呢個方法得, 整咗spare disk後佢自動重建, 等佢重建後再睇下有無事, 謝

TOP