回覆 30# fred2088


    USB and SDCARD Firmware flashing for the ARDUINO ATMEGA 2560 and ADK
https://github.com/FleetProbe/MicroBridge-Arduino-ATMega2560

TOP

本帖最後由 fred2088 於 2019-1-12 22:17 編輯

為 TinyBoy - Marlin 2.0.x 加入 打印完成後, 自動把印頭歸位及 把印件的Y 軸行到最出 ...
不用在 切片加 GCode

https://www.hkepc.com/forum/redi ... 57&pid=38094578

TOP

手動換絲選項

M62.jpg
2019-1-12 22:07

TOP

支援 Prusa MMU2 ...

mmu.png
2019-2-2 22:49

TOP

TOP

本帖最後由 fred2088 於 2019-3-24 19:33 編輯

關機續印 - SD卡打印合用 ...
Continue after Power-Loss Option
m69.png
2019-2-17 00:16


This feature operates without a power-loss detection circuit by writing to the recovery file periodically (e.g., once per layer), or if a POWER_LOSS_PIN is configured then it will write the recovery info only when a power-loss is detected. The latter option is preferred, since constant writing to the SD card can shorten its life, and the print will be resumed where it was interrupted rather than repeating the last layer. (Future implementations may allow use of the EEPROM or the on-board SD card.)

New M-Code to enable/disable Power-loss Recovery
http://marlinfw.org/docs/gcode/M413.html

TOP

2.0.x 支援機箱溫度 Sensor
#define TEMP_SENSOR_CHAMBER 0

TOP

沒有大不了的功能, 但貼心 : 再打印同一檔案, 按選擇便可 ...
m66.png
2019-3-18 10:50

TOP

marlin-config
fred2088 發表於 2019-2-4 09:29

好怕答問題!   仲要咁多條!

via HKEPC IR Pro 3.5.1 - iOS(2.4.1)

TOP

Filament Width Sensor ... 高級用戶之選 ...

M77.jpg
2019-3-23 15:34

TOP