[開箱] AX 850

本帖最後由 gamer338 於 2010-9-23 23:34 編輯

My new AX850
DSCF0232.jpg
2010-9-23 21:26

DSCF0235.jpg
2010-9-23 21:26

DSCF0237.jpg
2010-9-23 21:26

DSCF0240.jpg
2010-9-23 21:26

DSCF0242.jpg
2010-9-23 21:26

DSCF0243.jpg
2010-9-23 21:26

Now compare with the Cooler Master ATCX840
DSCF0239.jpg
2010-9-23 21:26

DSCF0245.jpg
2010-9-23 21:26

DSCF0246.jpg
2010-9-23 21:26

With HX750
DSCF0248.jpg
2010-9-23 21:26

DSCF0249.jpg
2010-9-23 21:26


Then next is the installations.  Latter I would like to point out the different then my usually way

Installed

DSCF0250.jpg
2010-9-23 21:44

Now take a closer look at the connections!!!???!!
DSCF0251.jpg
2010-9-23 21:44

The AX850 come with the twenty + eight contacting connect ???!!!??
It takes me minutes to figure out how to install them.  I hope I'm correct!

Next the most scary moment:

Switch it on

DSCF0253.jpg
2010-9-23 21:44

One more step to Heaven or Hell

Power up

DSCF0254.jpg
2010-9-23 21:44

It works

DSCF0255.jpg
2010-9-23 21:44

All work well

DSCF0263.jpg
2010-9-23 21:44

running strong

DSCF0265.jpg
2010-9-23 21:44

This is Heaven
DSCF0266.jpg
2010-9-23 21:44

All appear in good & sounds good too.

This my first time encountered such ways of installation.  But did learned a  new experance.  
This unit have no instruction to advice the user how to handle it.  Hopping one day Corsair will improving in the near future!
Thanks 4 watching.
PS: This is my first time post photos in this forum too

750换850?冇必要吧。ps:线有D乱哦

TOP

本帖最後由 gamer338 於 2010-9-23 22:52 編輯

Don't worry, the 750 will install to another computer which are running with E8400 + X38 chip, 4850 cf on board!

TOP

本帖最後由 kenn 於 2010-9-23 22:59 編輯

I am also using AX850, but I place it upsidedown (i.e. with the intake fan facing downward) to prevent dust going inside the PSU; moreover fresh air from the bottom is cooler than the warm air inside the case.

TOP

本帖最後由 gamer338 於 2010-9-23 23:10 編輯

Anyway, only want to point out the 24pins plug now in a new way 4 installation, it's became 20pins + 8pins plugs.  At 850 there are two 8pins female plugs on board.  Quite confusing to choose which one is correct.  Cause have no instruction even at the web at all.  For me this is the  first time encountered .

About the cables, it's too short to manage.  I'll try to found longer one to replace them.  Hopping I can fix them.  Thank-you 4 your pointing out.

TOP

CHING, You can search my post, I have similar config with you :)

ATCS840 and AX1200 with dual power Cooler Master M1000

Support your good post!

TOP

本帖最後由 gamer338 於 2010-9-23 23:19 編輯

To Kenn, Thanks 4 your advice.
As you can see I have cat, not only one but two.  They provide lots of hair that makes me have to cleaning  every two three days.  That's why I install two 12cm fens infront of the psu to provide cooling air.  At front pannel also have a 23cm fen too.

TOP


唔知呢張图帮唔帮到你

TOP

回復 6# 430

Thanks!  Can you give me the link.  Beside is your AX1200 the 24pins also have to install the same way as I did??!!  Did you have the installing instruction, if have can you share with me??  I'm quite thankful to you!!!

TOP

回復 8# xuk

Thanks a lot.  At your chart have point out the main board are 20+4.  But my 850 is 20+8 & must plug into two females at one upper one lower ways.  This is my first time saw it.

TOP