ocz vertext aligment 後唔見左

之前係我的電腦仲見到. 但係根住ocz 既做aligment ,即係係cmd 打d 野, reboot 後我的電腦就見唔到了, 咩事

原帖由 咪王$$$ 於 2009-6-3 19:07 發表
之前係我的電腦仲見到. 但係根住ocz 既做aligment ,即係係cmd 打d 野, reboot 後我的電腦就見唔到了, 咩事

你要在最後做一次快速format先得

[ 本帖最後由 2.4c 於 2009-6-3 20:41 編輯 ]

TOP

原帖由 2.4c 於 2009-6-3 20:40 發表

你要在最後做一次快速format先得

咁而家點? 我的電腦都見唔一,到點format?

TOP

You don't really have to do alginment if you r going to install vista/win7

TOP

喺 Diskpart 度 create partition primary align 後,有冇 active 先再 exit?

TOP

原帖由 NX 於 2009-6-3 21:08 發表
喺 Diskpart 度 create partition primary align 後,有冇 active 先再 exit?

有,,,,,,,

TOP

根足佢做
To start...vertex is NOT aligned correctly from the factory.This means we need to align it before we load the OS to it.

Connect Vertex to either sata port 0 or port 1 on your motherboard. You can use either IDE mode (native/legacy) or AHCI mode or raid mode (this being a non member raid disk...this is my preferred method over all others).

Grab the Vista recovery disk..details here http://www.ocztechnologyforum.com/fo...56&postcount=3
Rookie also gives a good guide there on how to align the partition, he sets an offset of 32KB, you can use any of the following with a single disk and they will give you no issues.

32 64 128 256 512 1024KB...these are for single disk ONLY.

Here is a break down of how i attack Diskpart:

1 once the cmd window is open type diskpart

2 list disk

3 select disk X with X being the number given for your ssd

4 clean

this destroys all partition/volume data on the disk.

5 create partition primary align 64

6 active

7 exit

Now close down the cmd box and reboot the PC

TOP

你係指係BIOS認都認唔到定入到Win見唔到?

如果係後者 windows個manage管理 or hardware device manage見唔見到隻ssd?

TOP