我用SliverStone /CoolerMaster 同 AMP 出品GA 線~O~

TOP

原帖由 idolclub 於 2007/1/25 14:25 發表




Yesterday I bought 4 Molex SATA cables at $5 each in New Golden.
Three of those had the same part no. as above and with latch (扣) at one end only.

The other Molex cable has the P/N 88758-0210 without any latch (扣).

The Gigabyte yellow one was also available at also $5 each.

[ 本帖最後由 ciel 於 2007-1-29 00:14 編輯 ]

TOP

Test for a slow SATA HD

I found that for slow HDs, the types of SATA cables is not so important.

The two types of SATA cables I used did not differ much for a 120 GB SeagateST31020827AS SATA I HD.

1. Molex Cable

2. ASKA Cable

[ 本帖最後由 ciel 於 2007-1-29 00:17 編輯 ]

TOP

new golden where can buy Molex SATA cables?

TOP

Nice post.

Anyway I suggest you retest with the following changes:

- Test with a larger file (e.g. 100MB+), since small file transfer result will be affected by the overhead.
- Test using another SATA drive other than your primary disk

It should give a more realistic result.

TOP

係無ga

提示: 作者被禁止或刪除 內容自動屏蔽

TOP

原帖由 hofct 於 2007-1-31 07:13 發表
Nice post.

Anyway I suggest you retest with the following changes:

- Test with a larger file (e.g. 100MB+), since small file transfer result will be affected by the overhead.
- Test using an ...


Test with larger file (e.g. 100MB+) will make the bottom neck goes to the buffer/access time of HDD, which will vary very much.  The method used in ATTO is suitable to review the quality of cable, as it just loop to get a defined size of data from 4K to 1M.

TOP