[測試] 試畫Delta Laser Cut

bunbunlui

將Delta既列印件轉左做Lasercut件, 俾冇printer又想自己砌既師兄DIY
唔知有冇野畫漏

下載 (133.81 KB)

2014-4-22 20:06

789456123

支持 ,雖然睇唔明.

bunbunlui

下載 (130.27 KB)

2014-4-22 20:43

個Design係for 2020鋁型材加6mm光軸, 加埋上面幅圖應該易明D

secmaster

有冇成品圖?

bunbunlui

未有, 只係今日畫出黎

hktvro

正想整部Kossel玩玩 ,支持樓主無私分享 , 加油 !

ptawong

個Design係for 2020鋁型材加6mm光軸, 加埋上面幅圖應該易明D
bunbunlui 發表於 2014-4-22 20:44

    原本8mm光軸,可能不夠,現改10mm板本
http://www.thingiverse.com/thing:154832

secmaster

回覆 7# ptawong


    我砌嗰部木頭都係8mm

bunbunlui

師兄8mm唔夠既意思係唔夠精度定係唔穩陣?
6mm唔夠既話要睇下點改10mm

下載 (138.29 KB)

2014-4-24 18:22

ptawong

FYI--

UPDATE: 01/02/2014
As it was noticed by Senormeow http://www.ohmpie.com/delta_printer/, the 8mm rods are not sturdy enough for this height. I will be uploading stl files for 10mm rods version soon which should help to make it more rigid. If you decide to use 8mm rods anyway then I would advice to use shorter extrusion lengths for the columns or lower top frame by 10-20cm. Bear in mind it's still work in progress ;), thanks

師兄8mm唔夠既意思係唔夠精度定係唔穩陣?
6mm唔夠既話要睇下點改10mm
bunbunlui 發表於 2014-4-24 18:23