[改裝] DIY M2 heatsink and fan

ckwk

下載 (66.9 KB)

2020-5-21 18:32

old heat sink from X bao, only tighten by rubber band

teperature before as with this heak sink

下載 (49.32 KB)

2020-5-21 17:27

new x Bao heatsink with bottom plate

下載 (141.47 KB)

2020-5-21 17:28

gel paste and screws

下載 (148.07 KB)

2020-5-21 17:28

3 cm fan and mod to 4 pin on board

下載 (127.04 KB)

2020-5-21 17:28

combined together

下載 (142.2 KB)

2020-5-21 17:28

kitme

AFTER 呢?

ckwk

下載 (43.97 KB)

2020-5-21 18:10

after
it take time to install

ckwk

the fan set 30-40%, no extra noise.
temperature down as 20 degree celcius,
cost less than HK$40

Levin_power

幾多cm

happychanbb

the fan set 30-40%, no extra noise.
temperature down as 20 degree celcius,
cost less than HK$40
ckwk 發表於 2020-5-21 18:14

螺絲直接落heatsink?

ckwk

回覆 5# Levin_power


    this fan is 3cm 5v 2 pin cable, i will try to 2.5 cm 12 v 2 pin fan soon

ckwk

回覆 6# happychanbb


    yes, and it is easy job.

ckwk

回覆 5# Levin_power

fan 的大小主要睇旁邊有幾多位

下載 (144.35 KB)

2020-5-22 10:19

ckwk

下載 (130.05 KB)

2020-5-22 12:50

改用 4 cm 3 pin 風扇

下載 (144.12 KB)

2020-5-22 12:50

呢個溫度，心滿意足了

分享，之前2 pin 3 cm 風扇，因為行5V, 開机好嘈,
直至fan control software 限電量才無聲
滿上4 cm 3 pin 風扇後，可以話加了風扇都唔覺，
溫度降15-20度
DIY 成本低， Cryorig Frostbit M.2 買唔起,
新底板陸續有M2 heatsink 可知底板廠想法，
thanks for watching