本帖最後由 luke123 於 2020-8-24 13:11 編輯
Hi
Just built a DeskMini A300 for a friend.
3200G with AMD Wraith Stealth CPU cooler (after removing shroud).
Blank screen. No Post. 
Tried all the usual troubleshooting tasks (incl. clearing CMOS with a screwdriver, disconnecting the CMOS battery, removing one RAM module, etc). Still no Post.
UPDATE: Front panel power LED and HDD LED never light up, even though CPU cooler fan is spinning. Bad news? Could this be a motherboard failure?
Looking back, I fully tightened all four screws securing the AMD Wraith Stealth CPU cooler, so that no further tightening is possible. Could this be the "No Post" cause?
Found:
1. rings CHing's post
https://www.hkepc.com/forum/view ... ;page=1#pid39598318
***第一點, 以我經驗是, 用其他風扇拆咗主機果背板之後, 上螺絲上太緊的話, 會
- 開唔到機,
- 只能行single channel
- 間中Hang 機等等
最後, 擰鬆D螺絲, 等主機板唔好咁受壓, 就正常好多
So far, 到現在都沒乜點hang 過***
2. chanuman CHing's post
https://www.hkepc.com/forum/view ... ;page=1#pid39599671
***我之前試過裝原裝風扇後開唔到機. 以為新買未用過就壞左. 點知想拆哂D野出黎換把AMD風扇試下. 又得返. 可能真係同螺絲太緊有關.***
Did any CHing have a similar "No Post" experience with the A300 (esp. using AMD Wraith Stealth CPU cooler)? If so, did you loosen the four CPU cooler screws and got Post again?
How much should the four screws be loosened? Half a turn? One full turn?
Any suggestions most welcome! |