kamsiu

我都更新了,暫時未知有咩分別
Thx

AAA1

Inside the update file:

1
Fixed a power management condition where the device failed to respond to COMWAKE, which might have resulted in the SSD not responding without being reset by the host.
2
Fixed the normalized value calculation for SMART Attribute 9 (Power-On Hours)
3
Fixed a SATA error recovery sequence coming out of PS1.
4
Fixed an issue during SMART self-test extended that could cause an unexpected read error.
5
Fixed an issue that could have caused the read thresholds to be artificially low during read disturb operations.
6
Fixed an issue that could have caused the drive to be unresponsive based on a flash program failure.
7
Fixed a theoretically possible instance where an UECC on the flash media while processing unaligned write commands that cannot be corrected by the ECC engine and RAISETM causes invalid data to be returned.

Miipp

佢個 Upgrade Tool 夾唔到 win7 64-bit + raid mode

cleverandy

佢個 Upgrade Tool 夾唔到 win7 64-bit + raid mode
Miipp 發表於 2013-3-30 22:36

你指GE係行左RAID的話就用不到?

ricky1992

洗唔洗去番ide mode先?
intel z77

cleverandy

洗唔洗去番ide mode先?
intel z77
ricky1992 發表於 2013-3-30 23:41

我用我隻S511經歷過我AMD平台(880G)同INTEL平台(Z77)
2個平台都唔洗轉咩野,直接係入面更新就得,我係行AHCI的

bdmoon

我隻係S511. 唔知點解行AHCI SCAN唔到隻SSD, 行IDE就SCAN到, 不過update完個firmware仍然係舊ver... 我舊ver係3.3.2.

Miipp

你指GE係行左RAID的話就用不到?
cleverandy 發表於 2013-3-30 23:19

64-bit 加 raid mode, 兩樣野都改唔到, 所以唔知邊樣失效 (scan 唔到隻 511)

Miipp

我隻係S511. 唔知點解行AHCI SCAN唔到隻SSD, 行IDE就SCAN到, 不過update完個firmware仍然係舊ver... 我舊ve ...
bdmoon 發表於 2013-3-31 00:31

check 返啊 D 部機, 佢係 win7 64-bit + AHCI, 上次係用佢部機來 update 的. 即係個 tool 唔多夾南橋模式

AAA1

I can update using Win 8 64bit AHCI but not ide
For raid, usually need to update separately under AHCI, i.e. disable raid