原帖由 happy_gemini 於 2009-6-24 11:05 發表


Then what was used in the SSD RAID we saw in the YouTube video?
(I don't remember exactly but there was a YouTube video showing a team building a SSD RAID with a huge number of SSDs...)


I remember that. But I was curious at that time too. Why just 2GB/s but there were 24 SSDs needed? Even a normal SSD for 200MB/s read, 24 of them should well over 4GB/s already.

TOP

原帖由 K_C_ 於 2009-6-24 11:10 發表


I remember that. But I was curious at that time too. Why just 2GB/s but there were 24 SSDs needed? Even a normal SSD for 200MB/s read, 24 of them should well over 4GB/s already.


By the way, I have another question as I haven't used a SSD so far.
For SSD's, is it necessary to keep the SSD always connected to the power supply?
By that I mean - will the data stored be lost after the SSD is disconnected for some time, e.g. 1 day or even a couple of hours?

TOP

原帖由 happy_gemini 於 2009-6-24 11:16 發表


By the way, I have another question as I haven't used a SSD so far.
For SSD's, is it necessary to keep the SSD always connected to the power supply?
By that I mean - will the data stored be lost af ...


Ooooops......

SSD is somehow designed to replace traditional HDDs...... so what do you think?

And also the memory chips inside a SSD are NAND flash, they are basically the same as those used in USB thumb drives, CF cards...etc, so what do you think again?

Hope this help.

TOP

原帖由 K_C_ 於 2009-6-24 11:22 發表


Ooooops......

SSD is somehow designed to replace traditional HDDs...... so what do you think?

And also the memory chips inside a SSD are NAND flash, they are basically the same  ...


Oh, yes, thanks for clearing my thoughts!

I just mixed it up with the DRAM-based SSD...

TOP

I have found out the following transfer rate information from relevant websites for our discussion:
DDR1-200: 1600MB/s
DDR1-400: 3200MB/s
DDR2-400: 3200MB/s
DDR2-800: 6400MB/s
ACARD: 400MB/s
SATA2: 3Gbp/s

3Ware AMCC RAID controller card with 8-ports RAID5 connected to 4 nos. of ACARD in 8-ports only achieved:
4xxMB/s in AS benchmark and 7xxMB/s in CrystalDiskMark. It is clear that ACARD is not good enough to fully utilize the potential of DDR2-RAM even using the slowest speed of DDR2-400 which should give 3200MB/s.

TOP

原帖由 輕基黃 於 2009-6-24 15:16 發表
I have found out the following transfer rate information from relevant websites for our discussion:
DDR1-200: 1600MB/s
DDR1-400: 3200MB/s
DDR2-400: 3200MB/s
DDR2-800: 6400MB/s
ACARD: 400MB/s
SATA2: 3G ...


I think you left the most important part of the puzzle here:

The 9650SE you got is PCI-e x 4 only. The max transfer rate is 1GB/s. With 7xxMB/s in CrystalDiskMark, that's not bad already IMO.

TOP

原帖由 K_C_ 於 2009-6-24 15:36 發表


I think you left the most important part of the puzzle here:

The 9650SE you got is PCI-e x 4 only. The max transfer rate is 1GB/s. With 7xxMB/s in CrystalDiskMark, that's not bad already IM ...

But why the AS SSD Benchmark achieved only 4xxMB/s? 7xxMB/s in CrystalDiskMark is still not satisfactory, it should approach 9xxMB/s. Do you think that changing to a PCI-e x 8 RAID can improve the transfer rate? Is there any PCI-e x 16 RAID in the market?

TOP

原帖由 輕基黃 於 2009-6-24 17:29 發表

But why the AS SSD Benchmark achieved only 4xxMB/s? 7xxMB/s in CrystalDiskMark is still not satisfactory, it should approach 9xxMB/s. Do you think that changing to a PCI-e x 8 RAID can improve the tr ...


I am not sure if there are any RAID cards with PCI-e x 16. And from here, Adaptec 5805 is capable for around 1.2GB/s on a PCI-e x 8 bus. So from all this info, we should really learn that those figures are simply theories (PCI-e x 8 should be up to 2GB/s) only. In the real world, that's another story.

[ 本帖最後由 K_C_ 於 2009-6-24 17:36 編輯 ]

TOP

阻阻各位以上的討論
小弟財疏學淺, 未玩過高科技, 想由淺入深, 先玩SCSI 34Gbs 死雞15000rmp, 想裝隻Window 7 64bit入去, 但在loading畫面認到呢兩隻hdd, 但到裝Window 7時, 就只得我果兩隻7200rmp既hdd同埋4Gbs i-RAM揀, 真無計, 裝window7 要成8Gbs多d
話時話, 果兩隻15000rmp真係好嘈好熱, 真擔心佢地會瓜柴

[ 本帖最後由 chiushing01 於 2009-6-24 21:33 編輯 ]
附件: 您需要登錄才可以下載或查看附件。沒有帳號?註冊

TOP

整部P45既slot都用到盡, vga+asus DX+intel adapter+ scsi+pci i-RAM, 望落好似好勁咁
估唔到行BENCHMARK會有呢個排名
1. i-RAM
2. 7200rmp hdd 32mb
3. scsi 40Gbs 15000rmp hdd

[ 本帖最後由 chiushing01 於 2009-6-24 22:44 編輯 ]
附件: 您需要登錄才可以下載或查看附件。沒有帳號?註冊

TOP